Publicidad
Idiomas disponibles
Idiomas disponibles
specifications
fireplace insert dimensions
(w x d x h)
net Weight
Voltage
frequency
Watts / amps.
heater rating
Electrical connection
A 15 Amp, 120 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this appliance.
Preferably, the fireplace insert will be on a dedicated circuit as other appliances on the same circuit
may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. the unit comes
standard with a 6 ft (1.8 m) long 3 wire cord, exiting out the back of the fireplace insert. Plan the
installation to avoid the use of an extension cord. If an extension cord must be used, it must be a minimum
14 ga, 3 wire with grounding type plug and connector and rated not less than 1875 watts. the extension
cord shall not be more than 20 ft (6 m) in length.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable regulations
to reduce the risk of fire, electrical shock and injury to persons.
WARNING: do not use this fireplace insert if any part of it has been under water. Immediately call a
qualified service technician to inspect the firebox and replace any part of the electrical system which has
been under water.
service instructions
For Your Safety
Service must be performed by qualified/authorized service personnel only.
Maintenance instructions
unplug the firebox prior to performing any maintenance.
1)
At least once yearly vacuum all dust and pet hair from air or heater vents
2)
Clean the outside of the glass with a damp cloth. Be sure the cloth is not wet. Wipe with a dry cloth
to remove streaks. do not use an abrasive cleanser on the glass
glass information
under no circumstances should this product be operated with a broken or chipped glass panel.
1.
2.
do not strike or slam the glass.
do not use abrasive cleansers to clean the glass.
3.
this product uses tempered glass. Replacement of the glass supplied by the manufacturer should be
4.
done by qualified/authorized service personnel only.
operating instructions
the firebox main power "on/off" switch must be switched "on" before any of the control functions, (on
the firebox and/or remote control) will operate. NOTE: the main switch does not have to be turned off
when the firebox is not being used for brief time periods. If however, you are not planning to use your
firebox for extended time periods or going away on vacation, we recommend the main power "on/off"
be switched off.
this firebox insert features conveniently separate controls for the flame effect and heat control.
4
28.3" x 9.4" x 20.1"
72 cm x 23,8 cm x 51 cm
30.9 lbs / 14 kg
120 V
60 Hz
1400W / 11.6A
4777 Btu's
Publicidad
