Num'axes PIE 1010 Manual De Instrucciones página 28

Time interval
PIR interval
Sensitivity
Time stamp
IR LED
Format
Password
Serial number
Factory setting
# PIE 1010 – indice A
blocks of time. This function can be set to "OFF" which means the
camera works all day.
OFF, ON
Time interval means the camera can capture images or videos at a
preset time interval regardless of whether motions are detected.
Changing this parameter to a non-zero value turns on the Time
interval mode, and camera will take photos or videos at given time
interval.
ON, OFF
This parameter indicates how long the PIR (Passive Infrared Motion
Detector) will be disabled after each triggering in ON mode. During
this time the PIR of the device will not react to the motion of humans
or animals. The minimum interval is 0 second which means the PIR
can work all the time. If you set it in OFF, it means the PIR will not
work even if it can be triggered.
Medium, High, Low
This parameter defines the sensitivity of the PIR sensor. The higher
sensitivity indicates that the camera is more easily triggered by
motion/heat, taking more pictures or recording more videos. It is
recommended to use high sensitivity in room or environment with
little interference, and to use lower sensitivity for outdoor or
environment with lots of interference like hot wind, smoke, near
window etc. Furthermore, the sensitivity of the PIR is strongly related
to the temperature. Higher temperature leads to lower sensitivity.
Therefore it is suggested to set a higher sensitivity for high
temperature environment.
ON, OFF
Select ON if you want the date and time (that the image was
captured) imprinted on every photo/video, select OFF for no imprint.
NOTE: the current temperature, moon phase and (user set) camera
serial number will also be imprinted on your still photos.
High, Medium
Controls how many LED lamps fire when images are taken in low
light. Set to "Medium" if you are getting overexposed flash photos or
will place the camera at very close range to the subject you want to
photograph.
Enter (followed by an additional Cancel/OK step)
Deletes (erases) all files stored on a card to prepare it for reuse.
Caution: make sure you have downloaded or backed up any files
you want to preserve first
OFF, ON
Allows the user to set a password for the camera (4 digits).
OFF, ON
Allow the user to set a serial number for the camera (4 digits). Useful
for ID purposes when multiple cameras are setup, since each camera
will imprint its name on all photos.
Enter (followed by an additional Cancel/OK step)
28/88