Sms Commands - Num'axes PIE 1010 Manual De Instrucciones

Cámara de rastreo
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

8. SMS commands

You have the option to control the camera remotely via text messages (SMS commands). You
can switch from photo mode to video mode and vice versa, take a picture and receive it, change
the video or photo resolution, etc.
To send a command to the device, you have to insert a code in a text message and send it to
the phone number of the SIM card inserted in the camera.
IMPORTANT
− The MMS or SMTP status must be set to "ON" (800x600, VGA or SMS) in the MMS/SMTP
setup for the SMS function to work. It will not work if the MMS or SMTP status is set to
OFF.
− Some towers do not support all commands.
− You must have a phone number entered in, in order to send commands to the phone. If
you only have an e-mail in the MMS/SMTP setup menu, you cannot use the SMS option.
The phone number in position 1 in the phone number list will be used as the "commander
phone number" and only it has the rights to edit the SMS command orders to control the
camera.
− Both MMS and SMTP allow control of the camera remotely via text messages.
The table below lists the actions or setting changes you can request and the various text
messages which you have to send to your camera:
# PIE 1010 – indice A
need to contact your mobile phone network operator to have them
provide all the required information.
Mobile no. – allows you to input the mobile phone number that can
control the camera with the SMS commands. Make sure to enter only
numbers (do not include any spaces or dashes).
Enter
Phone number 1
your choice
press MENU to move back
Email – allows you to input the email addresses that will receive data
from the camera. You can enter up to 4 email addresses.
Enter
Email 1 to 4
press MENU to move back
SMTP Manual Test – allows you to send an email manually for
testing.
Before starting the test, please make sure the SIM and SD cards are
inserted, the SMTP parameters are set correctly and the SMTP status
is not set to OFF.
You must allow your camera time to search for cellular service. After
the mobile signal shows on the LCD, your can begin the test.
Enter
Press OK to start the test. The camera will take a picture
automatically meanwhile the LCD will show a timer start to count the
transmitting time. Then a message on the LCD display will indicate if
the test is successful or not.
If the test failed check the camera settings and, if necessary, contact
your mobile phone network operator to verify the wireless related
data are correct.
press OK to input the phone number of
press OK to input email of your choice
32/88

Publicidad

Tabla de contenido
loading

Tabla de contenido