cecotec CUMBIA CREMMAET COMPACTCCINO BLACK Manual De Instrucciones página 25

ENGLISH
Menu and settings
In standby mode, press and hold the menu icon for 3 seconds to access the settings.
Temperature settings:
- After entering the menu, press the "MENU" icon to enter the temperature settings, you
can press "+" or "-" to adjust the coffee temperature.
- Automatic shut-off setting.
- After entering the menu, press "MENU" twice to enter the automatic shut-off setting. You
can press "+" or "-" to select the time, it can be set to 0.5h, 1h, 2h.... until 24h.
Start-up settings
After entering the menu, press the "MENU" icon 3 times to enter the start-up settings, this
function is only for professionals or customer service staff.
Manufacturing information
After entering the menu, click on the "MENU" icon 5 times and you will be able to check the
manufacturing information such as date and batch number.
Warnings and cautions
1. Empty coffee bean container
2. When the tank icon lights up, it means that the bean container is empty. Fill up the tank.
3. Double coffee
4. When the double coffee icon "x2" lights up, the double coffee function is activated. The
machine will brew two coffees at the same time with this function.
5. The machine will not brew the second coffee if the bean container runs empty during the
preparation of the first coffee.
6. Open panel
7. When the side cover icon lights up, it means that the right-side cover is open: close it.
8. Empty water tank
9. When the water tank icon lights up, it means that the water tank is empty or low on
water: fill it up.
10. Pressing unit not installed
11. When the pressing unit symbol lights up, it means that the pressing unit is not installed:
install it.
12. Coffee residues tank
13. When the waste-holding tank icon lights up, it means that the waste-holding tank is
not properly positioned or installed, or that it is full and needs to be emptied. Empty the
coffee grounds container every 8 cups of coffee.
14. Descaling
15. When the descaling icon lights up, it means that the machine needs to be descaled. See
the "descaling" instructions in the "Cleaning and maintenance" section.
48
16. Warning of water shortage in the internal pipeline
17. When the no water in internal pipe icon (FIGURE 5) is lights up on the control panel, it
means that there is a shortage of water in the brewer's internal pipe. Make sure that
there is water in the tank and that it is properly installed. Press the "EXIT" button to
restart the water pump and expel the air accumulated in the internal pipes.
4. CLEANING AND MAINTENANCE
Cleaning/rinse
1. Adjust the height of the coffee spout and place a cup underneath.
2. Touch the rinse button for 3 seconds to start cleaning/rinsing. This function uses about
60 mI of water and ends automatically after cleaning is completed. It is used to remove
possible coffee residues in the pipes.
Dismantling parts for cleaning
Fig. 4
1. Pull the water tank upwards by grasping it at the back and guide it out.
2. Pull the cover on the right side until it is removed.
3. Press the blue arrow at number 3 and pull the brewing unit outwards for cleaning.
4. The drip tray can be removed for cleaning by pulling it outwards. Inside you will see the
coffee grounds and all the coffee residues that have accumulated over time. You can
use the plastic brush to clean everything. Afterwards, dry it before placing it back in the
machine.
ATTENTION: When reinstalling the brewing unit, a snapping noise will be heard; if you do not
hear it, disassemble the unit again and reinsert it.
ATTENTION: Check whether the water tank is at the same level as the top of the machine, so
that it is positioned correctly. If this is not the case, push the water tank down until it clicks
into place.
Daily maintenance
Daily maintenance is important to extend the lifespan of the coffee machine and to always
produce good tasting coffee.
CREMMAET COMPACTCCINO BLACK / BLACK ROSE / WHITE ROSE / BLACK SILVER
ENGLISH
49