Publicidad
Idiomas disponibles
Idiomas disponibles
Precautions
1. Clean exposed parts with a soft, slightly damp cloth. To remove stains, use a mild soap. Never use
detergents, excess water, treated cloths, harsh cleaning agents, or sprays. Avoid contact with acids,
such as citrus juices.
2. Do not tamper with the scale's internal components. Doing so will invalidate the warranty on this unit
and may cause damage. The scale contains no user-serviceable parts.
3. Although your scale is designed to be maintenance-free, it contains sensitive electronic parts. Avoid
rough treatment. Treat it with care to ensure the best performance.
4. This scale is intended for home/consumer use only. It is not intended for commercial or medical use.
5. This scale is designed to read weights up to 6.6 lb x 0.1 oz / 3000 g x 1 g. To prevent damage, do not
place more than 6.6 lb / 3000 g on it.
6. Do not store scale where you store cleaning chemicals. The vapors from some household products
may affect the electronic components of your scale. Do not store scale on its side.
7. This scale is an extremely sensitive weighing device. In order to prevent run down of the battery, do
not store anything on the scale.
8. Do not dispose of batteries in fire. Batteries may explode or leak. Do not mix alkaline, standard
(carbon-zinc) or rechargeable (ni-cad, ni-mh, etc.) batteries. Remove the battery if the scale will not be
used for a long period of time.
9. Overload Warning: Should "O-Ld" appear on the display during a weighing, this indicates that the
maximum weighing capacity of the scale has been exceeded. Remove the weight immediately;
otherwise, permanent damage could occur.
10. Unstable Warning: Should "8888" display on the screen and then "----" appears, this indicates the
scale is unstable. Place the scale on a hard, level surface during use.
Caution: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Publicidad
