TREND CAB/JIG/A Instrucciones Originales página 8

Thank you for purchasing this Trend product, we hope
you enjoy many years of creative and productive use.
TECHNICAL DATA
Jig thickness
Min. Height Inset
Max. Height Inset
Max. Door Width
Drill Guide Diameter
INTENDED USE
This Jig is to be used to drill 4mm holes in door and
drawer fronts to aid the installation of handles and
knobs.
PLEASE KEEP THESE INSTRUCTIONS
IN A SAFE PLACE
The following symbols are used throughout this manual:
Refer to the instruction manual of your power tool.
Denotes risk of personal injury, loss of life or
damage to the tool in case of non- observance of the
instructions in this manual.
This template must not be put into service until it has
been established that the power tool to be used with this
template is in compliance with the latest local relevant
safety standards (identified by the marking on the power
tool).
SAFETY
Please read and understand the safety points in these
instructions as well as you power tool instructions
Follow your drill manufacturer's instructions
and safety guidelines.
Always wear eye protection.
The drill bit is sharp. Wear gloves when
handling an unprotected bit.
Use two clamps to secure the jig to the
workpiece. Do not attempt to hold it in place by
hand.
Keep body and hands away from sharp and
moving parts.
Safety Points
1. Disconnect power tool attachment from power
supply when not in use, before servicing,
6mm
25mm
120mm
600mm – 2 holes
730mm – 1 hole
4mm
EN - CAB/JIG/A
when making adjustments and when changing
accessories such as cutters. Ensure switch is in
"off" position and cutter has stopped rotating.
2. Read and understand instructions supplied with
power tool, attachment and cutter.
3. Current and complaint personal protective
equipment (PPE) for eye, ear and respiratory
protection must be worn. Keep hands, hair and
clothes clear of the cutter.
4. Before each use check cutter is sharp and free
from damage. Do not use if cutter is dull, broken
or cracked or if any damage is noticeable or
suspected. Only use tools in compliance with
the latest local relevant safety standards . Ensure
cutting tool is suitable for application.
5. Do not switch power tool on with the cutter touching
the workpiece.
6. Trial cuts should be made in waste material before
starting any project.
7. Repair of tools is only allowed according to tool
manufacturers instructions.
8. Do not take deep cuts in one pass, take shallow
passes to reduce the side load applied to the cutter.
9. User must be competent in using woodworking
equipment before using our products. Dress
properly, no loose clothing/jewellery, wear protective
hair covering for long hair.
10. Consider working environment before using
tools. Ensure working position is comfortable and
component is clamped securely. Keep proper
footing and balance at all times. Check work area
for obstructions. Keep control of power tool at all
times.
11. Please keep children, pets and visitors away from
tools and work area.
12. All tools have a residual risk so must therefore be
handled with caution.
13. Only use Trend original spare parts and accessories.
14. If you require further safety advice, technical
information, or spare parts, please call Trend
Technical Support or visit www.trend-uk.com
ITEMS REQUIRED
• Drill Driver
• 4mm Drill Bit* (type according to cabinetry door
material)
• PH2 Screwdriver
• Door handle* (required for jig setup when drilling 2
holes)
• Non-marring Clamps x2
-8-