Stihl FCB-KM Manual De Instrucciones página 13

English / USA
Do not adjust the deflector
The deflector has been set at the factory
so that the arrow on the deflector and
the open side point away from the
operator. This ensures that cuttings and
other debris are directed away from the
machine and operator.
12
: Tighten the wingnut clockwise.
: Standing in the normal working
position, check the depth of cut
again and correct it if necessary.
90°
Edging
: Start the engine.
: Start the cut at no less than half
throttle and continue cutting at full
throttle.
: Hold and guide your edger so that
the blade is vertical.
: Cut steadily so that the engine is not
lugged down – do not apply force.
: Cut at a normal walking pace.
: Do not push the blade into the
ground.
FCB-KM