Kärcher SC 4 Manual Del Usuario página 32

Care and maintenance
Only perform maintenance work if the
mains plug is unplugged and the steam
washer is cold.
Boiler flushing
Rinse the boiler of the steam cleaner after
filling it no more than 10 times.
Remove the plug from the power outlet.
Let the device cool down.
Empty the water container.
Remove the
accessory holder.
Figure
K
Open the maintenance cap. To do this,
place the open end of the extension
tube over the maintenance cap, snap
into the guide and unscrew.
Fill the steam boiler with water and
turn it vigorously. This removes lime
scale residues that have built up on the
bottom of the boiler.
Figure
L
Drain all water from the boiler.
Descaling lime from the boiler
Note
Because the equipment accumulates lime
scale, we recommend descaling it after the
number of water container fillings specified
on the table (TF= container fillings).
Resistance ºdH
range
I weak 0-7
II medium 7-14
III hard 14-21
IV very hard >21
Note
To find out the degree of water hardness in
your area, contact your local water supply
company or city hall.
32
accessory from
mmol/l TF
0-1.3 100
1.3-2.5 90
2.5-3.8 75
>3.8 50
Remove the plug from the power outlet.
Let the device cool down.
Empty the water container.
Remove
accessory holder.
Figure
K
Open the maintenance cap. To do this,
place the open end of the extension
tube over the maintenance cap, snap
into the guide and unscrew.
Figure
L
Drain all water from the boiler.
the
WARNING
An unsuitable descaler or the wrong dose
can cause damage to the equipment.
Use KÄRCHER descaler for descaling.
When using a descaling solution, follow
the dosage instructions on the package.
ATTENTION
The descaling solution can be harsh
on sensitive surfaces, so be careful
when filling and emptying the boiler with
this product.
Apply the
indicated in the instructions.
Fill with the steam boiler solution. Do
not close the steam boiler.
Let the descaling solution work for
8 hours.
Figure
L
Fully drain the solution from the boiler.
If necessary,
descaling process.
Rinse the steam boiler 2 or 3
times with cold water to remove all
solution residues.
Fully drain the water from the boiler.
Dry the power cord compartment.
Figure
K
Screw on the maintenance cap with an
extension tube.
Now the steam cleaner is ready to use.
the accessory from
descaling solution
repeat
the
as
the