Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to ensure proper tightness.
TOOLS REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(2) 7/16" wrenches
Utility knife
(1) 1/2" wrench
Tire pressure gauge
(1) 3/4" wrench
Pliers
ADJUST
SEAT (See Fig. 2)
•
Sit in seat.
•
Lift up adjustment lever (A) and slide seat until a com-
fortable position is reached which allows you to press
clutch/brake pedal all the way down.
•
Release lever to lock seat in position.
(1) 3/4" socket w/drive ratchet
(1) 9/16" wrench
Flashlight
When right or left hand is mentioned in this manual, it means
when you are in the operating position (seated behind the
steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK
CARTON
Remove all accessible loose parts and parts cartons
from carton.
•
Remove end panels and lay side panels flat.
•
Remove mower and packing materials.
•
Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING
TRACTOR
FROM
SKID
TO CHECK
BATTERY
(See Fig. 1)
Lift hood to raised position.
NOTE: If this battery is put into service after month and
year indicated on label (label is located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance
section of this manual
for charging instructions).
•
For battery and battery cable installation see "RE-
PLACING BATTERY"in the "Service and Adjustments"
section in this manual.
Fig. 1
Fig. 2
NOTE: You may now roll your tractor off the skid. Continue
using the instructions that follow to remove the tractor from
the skid.
_f_ WARNING:
Before starting, read, understand and fol-
low all instructions in the Operation section of this manual.
Ensure tractor is in a well-ventilated area. Ensure the area
in front of tractor is clear of other people and objects.
TO ROLLTRACTOR
OFF SKID (See Operation
section
for location and function
of controls)
•
Raise attachment lift lever to its highest position.
•
Release parking brake by depressing
clutch/brake
pedal.
•
Place freewheel control in "TRANSMISSION
DISEN-
GAGED" position.
(See "TO TRANSPORT"
in the
Operation section of this manual.)
•
Roll tractor forward off skid.
Continue with the instructions that follow.
TO INSTALL
MOWER AND BLADE
DRIVE
BELT (See Figs. 3 - 16)
1. SET PARKING
BRAKE
LEVER AND LOWER AT=
TACHMENT LIFT LEVER (See Fig. 3 and 4)
•
Depress clutch/brake pedal all the way down and hold.
•
Pull parking brake lever up and hold, release pressure
from clutch/brake
pedal, then release parking brake
lever. Pedal should remain in brake position.
Ensure
parking brake will hold tractor secure.
\/
6
Fig. 3
CAUTION: Lift lever is spring loaded. Have a
tight grip on lift lever, lower it slowly and en=
gage in lowest position.
Lift lever is located
on left side of fender.
Publicidad
