Publicidad
Idiomas disponibles
Idiomas disponibles
6. Wall Mounting the Enclosure
Mount the enclosure's back
B
door by itself to wall studs.
The number of hole cutouts
on the back door of the
enclosure will vary based on
your model. Each hole can
accommodate an M8, M10,
5/16" or 3/8" bolt. The holes
are centered 16" apart
horizontally to accommodate
the standard placement of
wall studs. The vertical
distance between the holes
will vary based on your
model.
C
Attach the enclosure cabinet
body and front door to the
mounted back door by
mounting the cabinet body
and securing it to the hinges
and nuts removed in Step 1.
Note: Enclosure must be
installed by a qualified
technician. Before mounting,
use a level and tape measure to
position your mounting area
precisely. Use appropriate
fasteners (not included) to
secure the enclosure to the wall.
A minimum of four fasteners is
recommended. A fender washer
with close cell foam is provided
with the cabinet. The close cell
foam side of the washer should
be against the cabinet to seal
the mounting hole. Use suitable
mounting means when installing
to cinder block, concrete,
drywall or wood studs. Warning:
The supporting surface must
be able to safely support the
combined load of the
equipment and all attached
hardware and components.
For the actual weight, size
and load capacity of the
enclosure, view the product
specifications and other
support resources at
tripplite.com/support.
B
C
21.53 in.
292.77 mm
Your model's hole configuration
8
16.00 in.
406.40 mm
may be different.
Publicidad
