Publicidad
Idiomas disponibles
Idiomas disponibles
3
1
1. Foot Base
2. Handle Receiver Tube
3. Lower Leg Support
4. Handle
B
clockwise until it locks onto the tube.
Version Juin 2023
4
2
A. Fasteners
Screws (4No.)
a.
Hex. Allen
Key
C: Height
A
Adjustment Knob
Step 4
Slacken the knob on the
Lower Leg Support (Item 3) by
turning the Height
Adjustment Knob (Item C)
anticlockwise until it is
possible to slide the unit over
the top of the handle receiver
(Item 2). Once the Lower Leg
Support is attached, lower the
support to the required height
and then tighten the Height
Adjustment Knob by turning it
Carefully unpack all parts of the RS1 Patient turner
and place the base on a flat surface
Step 1
Position the handle
Receiver tube (Item
2) into the centre
section of the Foot
base (Item 1) as
shown.
Step 2
Position the screws each
of the four holes in the
upright of the base and
tighten them one at a
time with the Hex. Allen
key supplied
Step 3
Slide the spring steel onto the
handle receiver (Item2) if it is
not already fitted to the top of
the receiver.
10
Publicidad
