Bosch MUM58M59 Instrucciones De Uso página 30

en Cleaning and servicing
Cleaning and servicing
The attachments and accessories used
must be thoroughly cleaned after each use.
X Table O
Attention!
Do not use abrasive cleaning agents.
Surfaces may be damaged.
Cleaning the base unit
W Danger of electric shock!
Never immerse the base unit in water or
place under running water. Do not use a
steam cleaner.
■ Remove mains plug.
■ Wipe the base unit and drive cover with
a damp cloth. If required, use a little
detergent.
■ Then dry the base unit.
Cleaning the bowl and tools
The bowl and tools are dishwasher­proof.
Do not wedge plastic parts in the dish­
washer, as they could be permanently
deformed during the washing process!
Cleaning the continuous-feed
shredder
W Risk of injury from sharp blades!
Do not grip the sharp blades or edges of the
cutting discs. Clean them with a brush.
All parts of the continuous­feed shredder
are dishwasher­proof.
Tip: To remove the red film after processing
e.g. carrots, pour a little cooking oil on
a cloth and rub the film off the continu­
ous­feed shredder (not the cutting discs).
Then rinse the continuous­feed shredder.
Cleaning the blender
W Risk of injury from sharp blades!
Do not touch blender blades with bare hands.
The blender jug, lid and funnel are
dishwasher­proof.
30
Tip: After processing liquids, it is often suffi­
cient to clean the blender without removing
it from the appliance. Pour 700 ml of water
and a drop of washing­up liquid into the
attached blender. Switch on the blender
for aproximately 1 minute (setting 7). Pour
out the water and rinse out the blender with
clear water.
Important information
If required, clean accessories bag. Follow
care instructions in the bag.
Storage
W Risk of injury!
When the appliance is not in use, pull out
the mains plug.
Fig. K:
■ Store tools and cutting discs in the
accessories bag.
■ Keep accessories bag in the bowl.
Troubleshooting
W Risk of injury!
Before eliminating a fault, pull out the
mains plug.
Important information
The Operating indicator flashes if the appli­
ance has been operated incorrectly or the
electronic fuse has tripped or the appliance
is defective.
The swivel arm must be engaged in
every operating position.
Initially try to eliminate the problem which
has occurred with the help of the following
information.
Fault
Appliance does not start.
Remedial action
■ Check the power supply.
■ Check the mains plug.
■ Check swivel arm. Correct position?
Engaged?
■ Screw on blender or bowl as far as
possible.
■ Attach the blender cover and screw on
as far as possible.