Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE:Your grill may NOT be equippedwith a
Sidebumer!
SideburnerIgnitorLighting
• Donot lean overgrill while lighting.
1. TurnO OFF gas burnercontrol valves.
2. TurnON gas at LPcylinder.
3. Open sideburnerlid.
4. Turnsideburnerknob to the _ HIGHposition,push
and hold ELECTRONICIGNITORbutton.
5. if sideburnerdoes NOTlight within 5 seconds,turn
knob to O OFF, wait 5 minutes,thenrepeat lighting
procedure.
Sideburner MatchLighting
• Do not lean over grill while lighting.
1. TurnO OFF gas burnercontrol valves.
2. TurnON gas at LPcylinder.
3. Open sideburner lid.
4. Placelit match near burner.
5. Turnsidebumerknob to the _ HIGHposition. Be sure
burnerlightsand stayslit.
Burner Flame Check
, Removecooking gratesand heattents. Light burners,
rotate knobsfrom HIGHto LOW. Youshouldsee a
smallerflame in LOW positionthan seen on HIGH.
Performburner flame check on side burner,also.Always
check flame priorto each use. If onlylow flame is seen
referto "Suddendrop or lowflame" inthe
Troubleshooting Section.
:o:
Turning Grill Off
, Turnall knobsto the O OFF position.TurnLP cylinder
OFF by turninghand-wheelclockwiseto a full stop.
Ignitor Check
• Turn gas off at LPcylinder. Pressand hold
electronicignitor button. "Click"shouldbe heardand
spark seen each time ineach collector box or
betweenburner andelectrode.See "Troubleshooting"
if no clickor spark.
Valve Check
• Important: Makesure gas isoff at LP cylinder
before checking valves. Knobslock in OFF position.
To check valves,first push in knobs and release,knobs
shouldspring back. If knobsdo notspring back,
replacevalve assemblybeforeusing grill. Turnknobs
to LOWposition thenturn backto OFF position.Valves
shouldturn smoothly.
Hose Check
• Beforeeach use, checkto see if hosesare cut or worn
or kinked. Replacedamagedhoses beforeusing grill.
Use only valvelhose/regulator s pecifiedby
manufacturer.
11 1
SPIDER
ALIERT!
SPIDERAND WEBS
If yourgrill is gettinghard to light or the flame is weak,
check and cleanthe venturisand burners.
Spidersor small insectsare known to create
"flashback"problemsby building nestsand laying
eggs inthe barbeque'sventurior burner,obstructing
theflow of gas. The back-upgas can ignite behind
the controlpanel. Thisflashbackcan damageyour
barbequeand cause injury. To preventflashbacks
and ensuregood performancethe burner and venturi
tubeassemblyshouldbe removed andcleanedwhen
everthe barbequehas been idlefor an extended
periodof time.
General Grill Cleaning
, Do not mistake brownor blackaccumulationof grease
and smokefor paint. Interiors of gas grills are not
paintedat the factory (and should never be painted).
Applya strongsolutionof detergentandwater or use a
grill cleanerwith scrub brushon insidesof grill lid and
bottom.Rinseand allow to completelyair dry. Do not
apply a caustic grill/oven cleaner to painted
surfaces.
, Plastic parts: Washwithwarm soapywater andwipe dry.
• Do not use citrisol,abrasivecleaners,degreasersor a
concentratedgrill cleaneron plasticparts.Damageto
and failure of partscan result.
• Porcelain surfaces: Becauseof glass-likecomposition,
most residuecan bewiped awaywithbaking
soda!watersolutionor speciallyformulatedcleaner.Use
nonabrasivescouringpowderfor stubbornstains.
• Painted surfaces:Wash withmild detergentor
nonabrasivecleaner andwarm soapy water.Wipe dry
witha soft nonabrasivecloth.
• Stainless steelsurfaces: Tomaintainyourgrill's high
quality appearance,washwith milddetergentand
warm soapywater andwipe dry with a soft cloth after
each use. Baked-ongreasedepositsmay requirethe
use of an abrasiveplastic cleaningpad. Useonly in
directionof brushedfinishto avoiddamage. Do not
use abrasivepad on areaswith graphics.
• Cooking surfaces: If a bristlebrush is used to clean
any of the grill cooking surfaces,ensureno loose
bristlesremainon cooking surfacesprior to grilling. It is
NOTrecommendedto clean cookingsurfaceswhile
grill is hot.
Storing YourGrill
, Clean cookinggrates.
, Store indry location.
, When LP cylinderis connectedto gdll, storeoutdoors
in a well-ventilatedspace and out of reachof
children.
, Covergrill if storedoutdoors. Choosefrom a varietyof
grill coversofferedby manufacturers.
, Storegrill indoorsONLYif LP cylinderis turned off and
disconnected,removedfrom grill and storedoutdoors.
, When removinggrillfrom storage, follow "Cleaningthe
BumerAssembly' instructionsbefore startinggrill.
Cleaning the Burner Assembly
Followthese instructionsto cleanand/or replacepartsof
burnerassemblyor if you have troubleigniting grill.
1.Turn gas OFF at control knobs and LP cylinder.
2. Removecookinggratesand heattents.
3. Removecarryovertubes and hardwaresecuringburners.
4. Detachelectrodefrom burner.
NOTE: Removal/Detachment methodwill dependon
the burner configuration.See differentconfigurations
in illustrationsbelow.
5. Carefullylift each burner up and awayfrom valve
openings.
We suggestthree ways to clean the burnertubes.
Usethe oneeasiest for you.
(A) Benda stiff wire (a light weight coat hangerworks
well) into a smallhook. Runthe hook througheach
burnertube severaltimes.
(B) Usea narrowbottle brushwith a flexible handle(do
notuse a brass wire brush). Run the brushthrough
each burner tube severaltimes.
(C) Wear eye protection: Use an air hose to force air into
the burner tube and outthe burner ports.Check each
portto make sureair comes outeach hole.
6. Wirebrush entireoutersurface of burner to remove
food residue and dirt.
7. Clean any blocked portswith a stiff wire suchas an
openpaper clip.
8.Checkburner for damagedue to normalwear and
corrosion,some holes may becomeenlarged. If any
largecracks or holesare found, replaceburner.
VERY IMPORTANT:Burner tubes must reengage
valve openings.See illustrationsat right.
Correct burner-to-valve
J
engagement
9.Attach electrodeto burner.
10. Carefullyreplaceburners.
11.Attachburnersto bracketsonfirebox.
12. Repositioncarryovertubes andattach to burners.
Replaceheattents and cookinggrates.
13. Beforecookingagain on grill, perform a "LeakTest"and
"BurnerFlame Check".
Firebox
Electrode
!FirelJox
Burner
Support
Publicidad
