EarthQuake E43 Instrucciones De Ensamblaje página 11

Parts Online
(C•114
•
Ardisam.corn
Page 11
800-345-6007
Earthauake
ASSEMBLY INSTRUCTIONS AND PARTS EXPLOSIONS
E43 Model
TROUBLESHOOTING
Engine will not start
1. Power switch off 1. Flip switch to ON position
2. Spark plug wire disconnected
Connect spark plug wire to spark plug
Out of fuel 3. Refuel
4. Spark plug wet, faulty or improperly
gapped
4. Clean, replace or gap spark plug
5. Throttle control not held open 5. Squeeze throttle control when pulling recoil
handle
6. Fuel line hose not positioned in bat-
torn of gas tank
6. Push fuel line down into fuel in gas tank
Engine runs rough, floods during
operation
1. Dirty air filter
1. Clean or replace air filter
2. Choke partially engaged
Turn off choke
Carburetor out of adjustment
3. Call factory
Engine is hard to start 1. Stale fuel
1. Drain old fuel and replace with fresh.
Use gas stabilizer at end of season
2. Spark plug wire loose
Make sure spark wire is securely attached to
spark plug
Dirty carburetor
3. Clean carburetor, use gas stabilizer, new gas can
4. Throttle control not held open
4. Prime unit 3 more times, squeeze throttle when
pulling recoil handle
Engine misses or lacks power
1. Clogged gas tank
1. Remove and clean
2. Clogged air filter
Clean or replace
Carburetor out of adjustment or bad 3. Call factory
4. Spark plug wet, faulty or improperly
gapped
4. Clean, replace or gap spark plug
Engine runs, then quits
1. Gas cap not venting
1. Open manual venting gas cap screw all the way
open (counterclockwise)
2. Plugged fuel filter
Clean or replace
Carburetor out of adjustment or bad
3. Call factory
Engine revs too high
1. Carburetor out of adjustment
1. Call factory
Auger turns at idle 1. Idle speed too high
1. Adjust idle speed lower
2. Broken clutch spring
2. Replace spring
Auger turns, but has no power
1. Choke on
1. Turn off choke after engine is running
2. Carburetor out of adjustment
Call factory
Broken transmission
3. Call factory
4. Worn clutch shoes
4. Replace clutch shoes and spring
5. Worn engine lower seat
5. Call factory
Auger jumps 1. Blade damaged
_
1. Replace with new blade
Auger cuts slowly 1. Dull blade
1. Buy new blade, or have blade sharpened at fac-
tory
2. Damaged fishtail point
2. Replace fishtail point
Contact service provider If above remedies Mil at 800-345-6007.