Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Won't Fill
Won't Agitate
Won't Spin
or Drain
Load is Wet
•
Stops
Leaks Water
•
Is Noisy
•
Fills with the Wrong
•
Temperature Water
•
Cycle Selector
•
Advances Through
Off
Plug cord into live electrical outlet.
Check fuse or reset circuit breaker.
Turn the control dial to proper cycle and restart the washer.
Turn both faucets on fully.
Straighten inlet hoses.
Disconnect [loses and clean screens. Hose filter screens may be plugged.
Check fuse or reset circuit breaker.
Make sure the lid is completely closed.
Turn the control dial to proper cycle and restart the washer.
Pauses are normal. Wait and see if the washer will start again.
Check fuse or reset circuit breaker.
Straighten drain hoses. Eliminate kinked [loses. If there is a home drain restriction, call for drain
service.
Close lid and restart the washer. For your safety, washer will not spin unless the lid is closed.
Suds lock - caused by too much suds. Rewash without detergent. Use correct amount of a low-
sudsing detergent.
Unevenly distributed load. Redistribute the load, close the lid and restart the washer. Check for
leveling. Be sure water level is acceptable for load size.
A normal spin speed is recommended for heavy loads like jeans or towels.
Plug cord into live electrical outlet.
Check fuse or reset circuit breaker.
Close lid and restart the washer. For your safety, washer will not agitate or spin unless lid is closed.
This may be a pause in the cycle. Wait briefly and it may start.
Make sure hose connections are tight.
Make sure end of drain hose is correctly inserted and secured to drain facility.
Avoid extended soaking - soak for 30 minutes or less.
Avoid overloading.
Be sure washer is leveled properly as outlined in installation manual.
Weak floors can cause vibration and walking.
Operating sounds will vary depending on agitation speed.
Turn both faucets on fully.
If equipped with a temperature selector knob, be sure it is set directly on a temperature setting and
not between settings.
Make sure temperature selection is correct.
While the washer is filling, you may notice just hot and/or just cold water entering the tub when
cold or warm wash temperatures are selected. This is a normal function of the Automatic
Temperature Control (:select models] feature as the washer determines the temperature of the
water.
If Auto Temperature Control (:select models] is selected, cold water may feel warmer than cold
water from the tap.
Make sure [loses are connected to correct faucets and inlet connections. Be sure water supply is
regulated correctly. Flush water line before filling washer.
Check the water heater. It should be set to deliver a minimum 120° F (::49 ° C] [lot water at the tap.
Also check water heater capacity and recovery rate.
Disconnect hoses and clean screens. Hose filter screens may be plugged.
Extra Rinse (:select models] is selected.
14
Publicidad
