Technics SA-GX505 Manual Del Usuario página 9

Parametric EQ system ON/OFF button
(P. EQ SYS)
This button is used to turn the parametric EQ system ON or
OFF.
Fine mode select button (FINE)
This button is used to fine-adjust the center frequency of the
parametric EQ.
Slope changeover button [SLOPE (Q)]
This button is used to increase or decrease the slope of the
parametric EQ curves.
Parametric EQ/tone mode select button
(P.EQITONE)
This button is used to select parametric EQ mode or tone
mode.
Center frequency select/bass control
(CENTER FREQ/BASS)
This control is used to select the center frequency in the
parametric EQ mode or to adjust the low-frequency sounds
in the tone mode.
Frequency fevel/treble control
(LEVEL/TREBLE)
This control is used to adjust the frequency level in the
parametric EQ mode or the high-frequency sounds in the
tone mode.
24
@
@
Dolby Pro-Logic Surround ON/OFF button
(SURROUND)
This button is used to activate the Dolby Pro-Logic Surround
effect.
Dolby 3 stereo ON/OFF button (3 STEREO)
This button is used to activate the Dolby 3 stereo effect.
Center mode select button (CENTER MODE)
Each time you press this button, the center mode will change
as follows: NORMAL— PHANTOM— CENTER OFF.
Test signal button (TEST)
When using the center speaker and/or the rear speakers,
press this button to activate the test signal. Then adjust the
volume balance of the center speaker and/or rear speakers.
center speaker.
Rear speaker level adjustment buttons
(REAR LEVEL)
These buttons are used to adjust the volume level of the rear
speakers.