Fanimation KUTE5 52 Manual De Instrucciones página 13

How to Assemble Your Ceiling Fan Blades and Cap
1. Align blade holes with posts on the motor assembly
flywheel. Make sure the blade is fully seated against
the flywheel. Place blade plate over the blade with
holes aligned and assemble blade to flywheel using
serrated head screws, fully tighten the screws that
attach the blades to the motor assembly flywheel.
(Figure 1)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
2.
Remove one of the three screws in the support
bracket at the bottom of the motor assembly and
retain the screw for later and slightly loosen the
remaining two screws. (Figure 2)
3. Assemble the light plate assembly to the support
bracket using the two key slots in the light plate
assembly. Replace the previously removed screw and
securely tighten all three screws. (Figure 3)
4. Remove one of the three screws in the light plate
assembly. Retain the screw for later and slightly
loosen the remaining two screws. (Figure 4)
Blade Plate
3/16"-24
Serrated Head Screw
Blade Plate
Motor Assembly
Motor Assembly
Light Plate
Assembly
13
Motor Assembly
Blade
3/16˝-24
Serrated Head Screw
(2 each per blade)
Figure 1
HARDWARE USED:
Figure 2
Figure 3
Figure 4
X 10
X 5
Light Plate
Assembly