Fanimation KUTE5 52 Manual De Instrucciones página 14

How to Assemble Your Ceiling Fan Blades and Cap (Continued)
5.
Assemble the light kit wire cover to the light plate
assembly using the two key slots in the light kit wire
cover. Replace the previously removed screw and
securely tighten all three screws. (Figure 5)
6.
Secure the steel cap to light kit wire cover by
twisting in a clockwise direction. Do not over-tighten.
(Figure 6)
1. IMPORTANT: Using a full range dimmer switch (not
included) to control fan speed will damage the fan. To
reduce the risk of fire or electrical shock, do not use a
full range dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and fan
damage could result.
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
How to Operate Your Ceiling Fan
WARNING
WARNING
Light Kit
Wire Cover
Steel Cap
For illustrative purposes only-not
intended to cover all types of controls
14
Light Kit
Wire Cover
Figure 5
Figure 6
Figure 1
Main Fuse Box
Figure 2