Metz MECABLITZ 50 AF-1 digital Manual De Instrucciones página 96

Ocultar thumbs Ver también para MECABLITZ 50 AF-1 digital:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

camera's operating instructions)! In analogue cameras there must be a
film in the camera to test the TTL function!
i-TTL and D-TTL flash mode
The i-TTL flash mode is supported by cameras of Group E, the D-TTL flash mode
by cameras of Group D (see Table 1). i-TTL and D-TTL flash modes are advan-
ced variants of the normal TTL flash modes used with analogue cameras. Before
shooting, the flash unit fires a series of barely visible measuring preflashes. The
camera evaluates the reflected preflash light so that the subsequent flash expo-
sure is optimally adapted to the prevailing photographic situation. According to
the evaluation, the following flash exposure is adjusted by the camera to the
shooting situation (for more information see camera's operating instructions).
Setting procedure
TTL
TTL
F 5,6
7,5
105
m
mm
Zoom
After about 5 seconds the display stops flashing and the setting is saved auto-
matically.
TTL
" appears in the display.
96
TTL
• Press „Mode" until „
" flashes in the
display. The flash unit sets the i–TTL or
D–TTL flash mode according to the
camera model.
There is no special distinction between i-TTL
and D-TTL in the display.
The setting takes effect immediately.
i-TTL BL and D-TTL 3D flash mode
These digital TTL flash modes are only supported by cameras of the Groups E or
D if lenses are used that transmit distance data to the camera (for example,
„D–AF Nikkor lens"). When shooting this data is taken into consideration in
addition in adjusting the flash exposure.
Setting procedure
TTL
• Press „Mode"
until „
BL" flashes in
the display. The flash unit sets the i-TTL BL
or D-TTL 3D flash mode according to the camera
model. There is no special distinction between
i-TTL BL and D-TTL 3D in the display.
The setting takes effect immediately.
After about 5 seconds the display stops flashing and the setting is saved auto-
matically.
TTL
BL" appears in the display.
Some cameras do not support the BL or 3D function in combination with
SPOT exposure metering. These flash modes will then either be automati-
cally cancelled and/or cannot be activated in the first place! In these
cases, the normal i-TTL or D-TTL modes will be set.
TTL
BL
TTL
BL
F 5,6
7,5
105
m
mm
Zoom

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido