Descargar Imprimir esta página

Bosch HEI8054C Instrucciones De Instalación página 14

Ocultar thumbs Ver también para HEI8054C:

Publicidad

Idiomas disponibles

Idiomas disponibles

4.
Slide Range into Opening
Measure the back left corner of the range to the bottom
of cooktop (B). Adjust leveling legs until this height is
the same as the corner dimension.
B
NOTICE
To avoid risk of damage to the range oven door, do
not lift, push, or pull the range by holding the door
handle. After the door has been removed, reach
inside the top of the oven cavity to locate a ridged
area near the front of the oven. Take care not to
touch the oven heating element also located at the
top of the oven cavity, just behind the ridged area.
,
6.
Repeat in the back right corner.
Use a 11A"wrench to adjust front leveling legs so that
the height from the bottom of the cooktop to the floor
matches the height of the corresponding countertop
surface.
drawer
\
wren
adjustable
leg
CAUTION
It is recommended to wear gloves and long sleeves
to protect hands and forearms from abrasion and
potential scratches during the lifting process. It is
also recommended
to take off watches and jewelry
and to wear work shoes during installation for foot
protection.
1.
Remove oven door using the procedure "Removing the
Oven Door" on page 13 and lift the range off of the
packaging base.
2.
Plug in the power cord.
3.
Dampen countertop and floor at bottom of opening with
soapy water.
Note: Clean up any remaining soapy water
immediately after sliding the range in place.
4.
Slide the range into the opening, being careful not to
damage countertops, floors, or the range door or
warming drawer front. Do not apply pressure to
cooktop when sliding into position. Be careful not to
crimp the flexible electrical connector.
5.
Install the oven door using the procedure "Replacing
the Oven Door" on page 14.
English 12
9001079089 Rev A

Publicidad

loading

Este manual también es adecuado para:

Hei8054uHeip054cHeipo54uHiip054cHiipo54u