Publicidad
Idiomas disponibles
Idiomas disponibles
Installation of the sensors
To add a sensor, keep the "Configuration" button pressed for 3
seconds, a beep will sound and the left led will light up, (this indicates
that you are going to install sensors in zone 1), with a short press on
the "Configuration" button , it will change to the central led (zone 2),
and with another to the right led (zone 3).
Once the desired zone is selected, activate the sensor that you want
to install and it will connect automatically, then press the status
button or wait a few seconds to exit.
To activate a door opening sensor, open and close the door where it
is installed, to activate a movement sensor just pass it in front of it.
Install remote control
To add a remote control, keep the "Configuration" button pressed for
3 seconds, a beep will sound and the left LED will light up, then briefly
press the "Configuration" button 3 times, and the 3 leds will remain
on, then the remote control, press the open or closed candado, and
the remote control will remain linked to the control panel.
Delete accessories
The accessories are eliminated by zones, this means that a single
accessory cannot be eliminated, you must eliminate the zone where
it is located, thus eliminating all the sensors or controls that are in
the same zone.
To remove the accessories from an area, enter configuration mode by
keeping the "Configuration" button pressed for 3 seconds. Select the
desired zone with short presses on the configuration button. When
you are in the desired zone, keep pressing the configuration button
again to eliminate the sensors or commands linked to it, the control
unit confirms that the zone has been eliminated with 3 beeps and 3
LED flashes.
24
Publicidad
