Dexter 12ID2-25.1A Instrucciones Originales página 104

b) Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
c) Before the use of the charger and the battery pack, read the instruction manual for it carefully.
d) During the charge process, the current used should correspond to the current of the battery
charger.
e) Never let moisture, rain orsplashed water reaches the charging location.
f) The ambient temperature must not exceed 50°C. Never expose the device to direct insulation.
g) Only switch off the current when the battery pack has been inserted into the box or has been pulled
out of the box.
h)Storage-battery pack, which are defective or damaged or can no longer be recharged, must be
disposed of as hazardous waste. Hand them over at a special collection point Never harm our
environment.Do not throw unusable storage-battery pack away into the domestic waste,into fre
or into water.
EN
i) If the electrical cable is damaged, the wire may only be replaced by the supplier or by his repair
workshop. Have repairs carried out only by an authorized specialist only.
j) Use only storage-battery pack, which have been produced by the original manufacturer.
k) Always keep the surface of the charger free from dust and dirt.
l) Insert the battery pack into the charger. Follow the guidelines provided concerning polarity.
m) Always remove battery pack before working on the machine.
n) When the battery pack is outside the drill, cover the contacts to avoid short circuits (e.g. from tools)
0)Do not throw Li-ion batteries into water or fire, risk of explosion!
p)Protect the battery pack from impacts, and don't open it.
q)Never discharge the battery pack completely and recharge occasionally if not used for aprolonged
period.
r) Do not recharge non-rechargeable batteries, as they can overheat and break.
RESIDUAL RISKS: Even when the tool is used as prescribed it is not possible to eliminate all residual
risk factors. The following hazards may arise in connection with the tool's construction and design:
1. Damage to lungs if an effective dust mask is not worn.
2. Damage to hearing if effective hearing protection is not worn.
3. Health defects resulting from vibration emission if the power tool is being used over longerperiod of
time or not adequately managed and properly maintained.
WARNING: This machine produces an electromagnetic field during operation. This field may under
some circumstances interfere with active or passive medical implants. To reduce the risk of serious
or fatal injury, we recommend persons with medical implants to consult their physician and the
medical implant manufacturer before operating this machine.
MAINTENANCE
WARNING: Do not allow brake fluids, gasoline, petroleum-based products penetrating oils, etc...
come in contact with plastic parts. They contain chemicals that can damage, weaken or destroy the
housing, thus compromising the integrity of of the double insulation.
WARNING: Always disconnect the device before performing any adjustment or maintenance
operation. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent in order to avoid a hazard. Disconnect from the power supply immediately if the supply cord is
damaged. Take care not to expose this tool to the rain. If the carbon brushes need to be replaced, have this
done by a qualified repair person (always replace the two brushes at the same time) Your power tool
requires no additional lubrication or maintenance. Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage your power tool. The ambient temperature range for
this tool use is 0ºC - 40ºC. The relative humidity of the area must be not more than 80% without direct
exposure to rain and excessive dust content of the air There are some user serviceable parts in your power
tool.
Please refer to the list of spare part list of the manual.
104