Grundig M18-C Manual Del Usuario página 29

Dolby B Noise Reduction System
The Dolby B NR System is manufactured under
license from Dolby Laboratories Licensing Corporc
tion. The word Dolby and the O10 symbol are trade-
marks of Dolby Laboratories licensing Corporation.
1 Press OO B NR to switch on Dolby B NR.
The OG nr indication appears in the display.
"2: Press OO B NR again to switch off Dolby B NR.
— The QO NR indication disappears from the ,
display.
Notes:
— A tape recorded with the Dolby B NR system
should also be played in the Dolby B NR
mode. If you forget to operate the DOLBY NR
button, the treble may be reproduced too
strongly or too faintly.
- The ac B NR bution has no influence during
dubbing (dubbing from TAPE 1 to TAPE 2}. An
original tape recorded with Dolby B NR auto-
matically produces a copy with Dolby B NR.
Dubbing cassettes
(from DECK 1 to DECK 2)
1 Load the prerecorded cassette into TAPE DECK
T and a blank cassette intc TAPE DECK 2.
— Make sure that both cassettes have their full
spools to the lett.
2 Press SIDE to select the front side of the tape in
" TAPE DECK 2.
3 Press DUBBING and then press <€< or B>B> for
respective dubbing speed mode.
~ NORMAL (normal speed) or FAST {high speed}
appears on the display.
- HSD appears on the display for high speed
dubbing.
4 Press DUBBING again to start recording.
~ The RECORD flag starts flashing.
5 Press il to stop dubbing.
Notes :
~ At the end of side A, flip the cassettes to side B
and repeat the procedure.
- Dubbing of cassettes is only possible in the
TAPE 2 mode. To ensure good dubbing, use
tapes of the same length.
~ During high speed dubbing in Tape mode, the
sound is reduced to a low volume.
— You can listen. to other sound source while
dubbing.
29