Sharpening Of Cutting Blades - TRAPP TRP 30 Manual De Instrucciones

www.trapp.com.br

Sharpening of cutting blades

TRAPP shredders leave factory with temperate
cutting blades, prolonging cutting durability.
Sharpen the cutting blades when the edge is dull.
Sharpen the side indicated only (Figure 3), trying to
keep its original inclination. Whenever sharpening,
be careful to remove the same amount of material
from each cutting blade to keep balance and to
avoid vibrations of the axle unit. The cutting blades
shall be substituted whenever optimum sharpening
is no longer possible.
Figure 3
Maintenance of the belts - TRP 400E / TRP 400G
To relieve the belt tension you will need to move the belt tensioning lever as shown in the following picture:
1. Remove the screw (1)
2. Remove the lock washer (2)
3. Remove the belt guard cover (3)
Figure 4
Attention!
Always turn off shredder and unplug it before
servicing or cleaning.
1
2
4
4. Belts
13
3
51