Publicidad
Idiomas disponibles
Idiomas disponibles
THE ELECTRONIC OVEN CONTROL
UltraBake
TM
electronic display
Kitchen timer set
and off pad
(pp. 16, 17)
TEMP
SELECTOR
I
@
Oven selector
Temperature
pad
pad
(bake, p. 18;
(pp. 18, 21, 23,
broil, pp. 22, 23;
25, 27)
clean, pp. 33, 34)
1]
Clock and
_ITO"EN
TIMER _
. | |
manual oven
...............
light pad
(p . 16, 40)
@@HOUR MIN
_
i
_
................
TIMED
OVEN
(
)
COOK
STAR T
STOP
TtME
TIME
TiME
Timed oven
Hour
Minute
Start/enter
control pad
pad
pad
and off/cancel
(pp. 25-29)
(pp. 16, 26, 27,
pad
28,33,34)
(pp. 15, 16, 17,
19, 21, 23, 26, 28)
• When you first plug in the range, everything on
the display will light up for 1 to 2 seconds, then
a time of day and "PF" will appear on the
temperature
display. Press OFF/CANCEL to clear
"PF" from the display. If, after you set the clock
(see "Setting the clock," p. 16), "PF" again
appears on the display, your electricity
was off
for a while indicating a Power Failure. Reset the
clock, if needed.
• When you are not using the oven, the control is
an accurate clock.
• When you are using the oven or kitchen timer,
the display will show times, temperature
settings, and what command
pads have been
pressed.
• When showing the time of day, the display will
show the hour and minutes.
• When you are using the kitchen timer, the
display will show minutes and seconds in the
following sequence:
- For settings from 1 to 59 minutes, the display
will count down each second.
- For settings one hour or over, the display will
count down each minute.
• When you are using cook time and/or stop time,
@
_
thedisplaywillshowhours
and minutes or minutes and
seconds.
Ust / g
cor t o 0@:
The control lock lets you shut down the control
panel command pads. The control lock comes in
handy when you want to prevent others from using
the oven.
NOTES:
• You can only use the control lock when the oven
is not in use or the control has not been set.
• Set the control lock when cleaning the control
panel to prevent yourself from accidentally turning
on the oven.
• The control lock will stay on even after a power
failure.
To lock the control panel:
Press and hold START/ENTER for 5 seconds.
P,,,,c
You will hear a single tone and "Loc" and
_ will appear on the temperature display.
When the control is locked, "START?"
will appear on the display and 3 tones
will sound if you press any command pad other than
clock or timer set.
To unlock the control panel:
Press and hold START/ENTER for 5 seconds. You
85s,c
will hear 3 t_nes followed by a single tone.
_
Loc" and [] will disappear from the
temperature
display.
15
Publicidad
