Makita CP100D Manual De Instrucciones página 6

Switch action
WARNING:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
WARNING:
For your safety, this tool is
equipped with the lock-off button which prevents
the tool from unintended starting. Never use the
tool if it starts when you pull the switch trigger
without pressing the lock-off button. Ask your local
Makita Service Center for repairs.
WARNING:
Never disable the lock function or
tape down the lock-off button.
NOTICE:
Do not pull the switch trigger forcibly
without pressing the lock-off button. The switch
may break.
► 1 . Switch trigger 2. Lock-off button
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, press the lock-off button and pull the
switch trigger. Release the switch trigger to stop. The
lock-off button can be pressed from either the right or
left side.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
The blade can be warm during
operation. Before removing the blade, wait until
the blade cools down.
CAUTION:
Be sure to secure the blade firmly
to avoid injury or damage to the tool.
CAUTION:
When replacing the blade, always
wear gloves so that your hands do not directly
contact the blade.
1
2
Replacing blade
1. Insert the lock pin included in the package of the
blade set into the free hole in the blade, and then loosen
the screw with a screwdriver.
► 1 . Screw 2. Lock pin
2. Remove the lock pin, and then remove the screw
and the blade.
3.
Attach the new blade with its flat surface facing the
tool, then insert the lock pin, and then tighten the screw
firmly to secure the blade.
► 1 . Blade 2. Screw 3. Lock pin
4. Remove the lock pin.
6 ENGLISH
1
2
3
1
2