L.B.White Premier 350 DF Manual Del Usuario E Instrucciones página 7

lation, troubleshooting, replacement of defective parts
and testing of the heater. You must be able to place
the heater into a continuing safe and normal operating
condition. You must completely familiarize yourself with
each model heater by reading and complying with the
safety instructions, labels, Owner's Manual, etc., that is
provided with each heater.
b. To be a qualified gas installation person, you must
have sufficient training and experience to handle all
aspects of installing, repairing and altering gas lines,
including selecting and installing the proper equipment,
and selecting proper pipe and tank size to be used.
This must be done in accordance with all local, state
and national codes as well as the manufacturer's
requirements.
c. In the Commonwealth of Massachusetts, this product
must be installed by a gas fitter licensed in the Com-
monwealth of Massachusetts.
2. All installations and applications of L.B. White heaters
must meet all relevant local, state and national codes.
Included are L.P. gas, natural gas, electrical, and safety
codes. Your local fuel gas supplier, a local licensed
electrician, the local fire department or similar govern-
ment agencies, or your insurance agent can help you
determine code requirements.
Refer to the following:
U.S. Installations:
-- ANSI/NFPA 58, latest edition, Standard for Storage and
Handling of Liquefied Petroleum Gas and/or
-- ANSI Z223.1/NFPA 54, National Fuel Gas Code
-- ANSI/NFPA 70, National Electrical Code.
Canadian Installations:
-- CSA B149.1 Natural Gas and Propane Gas Installation
Code.
-- CSA C22.1 Part 1 Standard Canadian Electrical Code
-- CSA C22.2 No.3, Electrical Features of Fuel Burning
Equipment.
3. We cannot anticipate every use which maybe made
of our heaters. Other standards govern the use of fuel
gases and heat producing products in specific applica-
tions. Your local authority can advise you about these.
Check with the local fire safety authority if you have
questions about applications.
4. Do not wash the interior of the heater. Use only
compressed air, a soft brush or dry cloth to clean the
interior of the heater and it's components.
Premier Ductable Heaters
5. For safety, this heater is equipped with manual
reset high limit switches, an air-proving switch and a
redundant gas control valve. Never operate the heater
with any safety device that has been bypassed. Do not
operate this heater unless all of these features are fully
functioning.
6. Do not locate fuel gas containers or fuel supply hoses
within 20 ft./6.10 meters of the blower outlet of the
heater.
7. Do not block air intakes or discharge outlets of the
heater. Doing so may cause improper combustion or
damage to heater components leading to property
damage.
8. The hose assembly shall be visually inspected on a
daily basis after heater relocation and when the heater
is in use. If it is evident there is excessive abrasion or
wear, or if the hose is cut, it must be replaced prior to
the heater being put into operation. The hose assembly
shall be protected from building materials, and contact
with hot surfaces during use. The replacement hose
assembly shall be that specified by the manufacturer.
See parts list.
9. Premier 350DF heaters are equipped with a gas
selector valve. The selector valve must be properly
positioned for the gas supplied to the heater. Further
information on this feature is provided on page 17 of
this manual.
10. Check for gas leaks and proper function upon heater
installation, when relocating, and after servicing. Refer
to leak check instructions within installation section of
this manual.
11. This heater shall be inspected for proper operation by
a qualified service person before each use and at least
annually.
12. Always turn off the gas supply to the heater if the
heater is not going to be used in the heating of the
work space.
13. This heater is equipped with a three-prong
(grounding) plug for your protection against shock
hazard and must be plugged directly into a properly
grounded three-prong receptacle. Failure to use a
properly grounded receptacle can result in electrical
shock, personal injury, or death.
14. If gas flow is interrupted and flame goes out, do not
relight the heater until you are sure that all gas that
may have accummulated has cleared away. In any
event, do not relight the heater for at least 5 minutes.
Owner's Manual • Premier 350 2.0
7