Therabody TheraFace Mask Guia De Inicio Rapido página 8

TheraFace Mask Device After Care & Cleaning
EN
Device Maintenance
The following maintenance instructions are important to ensure that
your device continues to work as it was designed. Failure to follow
these instructions may cause your device to stop working.
Care and Cleaning
1. Wipe the device clean with a disposable cloth after each use.
2. Before cleaning, power the device OFF by long pressing the LED
light button (G) or vibration button (H); ensure that your device is
not connected to a charging cable or power source before cleaning.
3. Visually inspect the device for any obvious signs of debris build-up.
4. Wipe off any visible dirt with a disposable cloth moistened with a
mild detergent. Be sure to wipe the interior surfaces of the mask.
Next, use a soft cloth stained with 70% isopropyl alcohol to wipe
and disinfect the mask for three (3) minutes, especially the inner
surface of the mask. Repeat this process three times. Finally, wipe
the disinfectant with a clean, dry cloth or towel until there is no
visible residue. Do not submerge the device in water or apply
excessive cleaning solution or disinfectant when cleaning.
5. If you use the TheraFace Mask eyeshield during your treatment,
wipe clean.
6. After cleaning, allow the device to dry thoroughly before storing or
beginning another treatment. A properly cleaned device should
have no visible signs of debris or moisture.
7 7
Charging:
• To check the battery level, short press the LED light
button (G) or the vibration button (H).
• Each light color corresponds with a battery level:
• Orange: Low-charge
• Blue: Mid-charge
• Green: Full-charge
• Before charging the TheraFace Mask, power the
device OFF by long pressing the LED button (G) or
vibration button (H).
• Connect the TheraFace Mask to the USB-C cable.
The port is located inside the mask.
• The battery level is displayed next to the USB-C
port.
• The LED will flash to indicate that the device is
connected properly and charging. This light will turn
green when charging is complete.
Note: If using an alternative USB-C cable, ensure that it is from a
trusted source and has not suffered any structural damage. Do not
try to use the device while charging.