Publicidad
Idiomas disponibles
Idiomas disponibles
Switch brush roller for carpet or hard floor
If the front button on the top of the handle is pressed, the rotation speed for the brush roller can be changed. We recommend
fast turning (
) for carpets and upholstery and slow turning (
Convenient stowage function
The appliance can be stored either on the wall bracket or upright in a cupboard or protected corner. To do this, the telescopic
tube must be pushed in completely. Never leave the appliance with the handpiece in a free-standing position in a room or
similar place to prevent it from falling over. An appliance falling over may cause injury or damage to the appliance/battery.
Emptying the dust container
The dust container can only hold a limited quantity of dirt.
It is therefore best to empty the dust container after every cleaning procedure and if the suction power noticeably drops.
1.
Make sure that the appliance is switched off and is not on charge.
2.
Take the suction tube off.
3.
Press the button
be emptied.
4.
Close the flap.
Cleaning the dust container and motor pre-filter
1.
Make sure that the appliance is switched off and is not on charge.
2.
Empty the dust container (see chapter 'Emptying the dust container').
3.
Turn the handpiece over so that the dust container is facing upwards.
4.
Unlock and remove the dust container lid by turning it anticlockwise.
5.
Unlock the dust container insert anticlockwise ( → ) and remove it.
6.
Remove the motor pre-filter from the dust container.
7.
Pull the foam cover off the filter and tap it out.
8.
Thoroughly tap out and brush off the filter. In doing so, turn the filter material inside out.
9.
Brush the dust container insert.
Note: All parts may be cleaned under running water. Make sure that all parts are completely dry before using the
appliance again. The drying time of the filter is about 24 hours.
10.. After complete drying of the individual parts, push the filter cloth into the filter.
11. Pull the foam cover over the filter and place the filter in the dust container.
12. Put the dust container insert over it and lock it in place by turning it ( → ).
13. Place the dust container lid on the hand part and lock it by turning it clockwise until
Maintaining the appliance
button on the side of the dust container. The flap opens and the contents of the dust container can
) for hard floors.
Storing the appliance
and
are facing each other.
17
Publicidad
