Powersmart DB2501 Manual De Instrucciones página 10

SPECIFIC SAFETY RULES
Only operate the machine in daylight or good artificial light.

When being used as an Edger, stones, pieces of metal and other objects can be thrown out at high

speed by the line. The tool and guard are designed to reduce the danger. However, the following
special precautions should be taken: MAKE SURE that other persons and pets are at least 100 feet
(30m) away.
Use only the manufacturer's 0.065 in. diameter replacement line in the cutting head. Do not use any

other cutting attachment, for example, metal wire, rope, or the like. To install any other brand of
cutting head to this brush cutter can result in serious personal injury.
Never operate unit without the grass deflector in place and in good condition.

Check damaged parts. Before further use of the tool, a guard or other part that is damaged should be

carefully checked to determine that it will operate properly and perform its intended function. Check
for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other
conditions that may affect its operation. A guard or other part that is damaged must be properly
repaired or replaced by an authorized service center to avoid risk of personal injury.
Never use blades, flailing devices, wire, or rope. Unit is designed for string trimmer use only. Use of

any other accessories or attachments will increase the risk of injury.
Keep the air vents clean and free of debris to avoid overheating the motor. Clean after each use.

Stop the unit and disconnect the power source when not in use. Carry the unit with the motor

stopped.
Do not use the brush cutter with any type of accessory or attachment. Such usage might be

hazardous.
Risk of cut. Keep hands away from the line. Keep both hands on handles when power is on.

Do not attempt to remove cut material or hold material to be cut when lines are moving. Make sure

the start switch is off when clearing jammed material from guard. Do not grasp the guard or lines
when picking up or holding the brush cutter.
Do not force the machine. It will do the job better and with less likelihood of a risk of injury at the

rate for which it was designed.
When not in use, the machine should be stored indoors in a dry and high or locked-up place, out of

reach of children.
10