Powersmart DB2501 Manual De Instrucciones página 16

GRASS TRIMMER HEAD REPLACEMENT
Install the lower pressing plate and the upper pressing plate into the motor shaft. Note: the convex

surface of the lower pressing plate shall face down.
Insert a screwdriver into the positioning hole of the motor and the upper pressing plate.

Tighten the brushless trimmer head counterclockwise.

Remove the screwdriver.

CONNECTING AND REMOVING BATTERY
IMPORTANT! The battery pack is not charged when it is purchased. Before using the power tool for
the first time, place the battery pack in the battery charger and charge. Make sure to read all safety
precautions, and follow the instructions in the battery charger section.
To install the battery pack
To install the battery pack into the bottom of the handle, align the rails of the battery pack with the rails in
the handle and push the battery into the handle. To connect the battery, slide the battery pack fully
forward. Until the latch locks into place.
To remove the battery pack
Press the battery release button ,Slide the battery pack backward, and then pull or lift the battery out of
the tool.
16