cecotec BOLERO SQUAD I 3100 Manual De Instrucciones página 32

ENGLISH
6. Bridge Zone 2
7. Control panel
8. Stop&Go touch icon
BBQ touch icon
9.
10. Keep Warm touch icon
11. Cooking-zone selection touch icon
12. Timer touch icon
13. Power/time slider
14. Lock touch icon
15. Power touch icon
16. Booster touch icon
17. Bridge-function touch icon
Note:
The graphics in this manual are schematic representations and may not exactly match the
product.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent product damage when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
Make sure all parts and components are included and in good conditions. If there is any
-
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Bolero Squad I 3100 / 3100 FullFlex / 4100 FullFlex hob
- Instruction manual
Before first use
Clean the induction hob with a dampened cloth and thoroughly dry the surface. Do not use
detergents that may taint the glass surface blue.
B O LE R O S QUAD I 3 10 0/3 10 0 FULLFLE X/4100 FU LL F L EX
62
3. INSTALLATION
Gluing the adhesive sealing gasket
The gasket supplied with the induction hob prevents liquid from seeping into the cabinet
below. The gasket must be carefully glued, as shown in Figure 4. For this purpose:
Clean the surface of the edge of the hob where the sealing gasket is to be fitted.
1.
2. Install the sealing gasket along the outer edge of the induction hob. Make sure that the
end of the cut sealing gasket reaches the end of the hob edge. When cutting the gasket,
try to leave a few extra millimetres. To fit the gasket, push the two ends together at a
corner and do not leave a gap between both ends. The sealing gasket must be installed to
ensure that no liquid leaks inside the induction hob.
Installation
The product must be installed by authorised specialists.
-
- The installer must comply with the legislation and standards in force in the country where
the product is to be installed.
- The distance between the induction hob and the surrounding walls must be at least 50
mm.
- Figure 5 and the following table show the size for the installation of the induction hob.
Model I W
Length (mm) Width (mm)
02510 590 520
02511 590 520
02512 590 520
Model A (mm)
02510 560
02511 560
02512 560
When installing the induction hob, there may be a wall or a tall cabinet at the rear or on one
-
side. Should it be the case, there must not be any furniture or appliances that are higher
than the cooking surface on the opposite side (opposite to the rear or one of the sides).
- The installation worktop and the objects close to it must be heat resistant (100 °C). The
sealing gaskets at the edges of the wall must be heat-resistant.
- Do not install the induction hob on top of a dishwasher or a non-ventilated oven.
BO LERO SQUA D I 3100/31 00 FULLFLEX/4100 FULLFLEX
ENGLISH
H D
Height (mm) Depth (mm)
60 56
60 56
60 56
B (mm) X (mm)
490 Min. 50
490 Min. 50
490 Min. 50
63