Publicidad
Idiomas disponibles
Idiomas disponibles
3. Blade change
• Remove the blade protection and remove the plastic protection as shown in the image below:
• Raise the blade to its maximum point to facilitate removal;
• Place the spanner on the outer flange (f) of the disc and loosen the screw with an Allen (h) key and remove it;
• Remove the old saw and position the new one, make sure that the teeth point to the direction of rotation as
shown on the saw;
• Position the outer flange on the saw shaft, lock it with the spanner, position the shaft screw and tighten it
with the Allen key;
• Position the plastic bench protection and tighten its screws;
•
Install the blade guard (3);
4. Adjusting the guide ruler
Guide ruler is used to determine cutting dimensions in the table saw.
• Position the guide (5) on the bench, and slide it to the desired position and tighten its knob.
9. OPERATION
Use Instructions:
1. Check whether the guide fence has been mounted correctly.
2. Do not saw any other materials than wood.
3. Turn on the machine only after all adjustments have been made.
4. Do not exert pressure on the saw blade. Allow the machine enough time to cut the workpiece.
5. Never try to slow the saw blade down by exerting pressure on the side.
6. lf the saw blade comes to a standstill or decelerates, the machine is being overloaded. lmmediately
stop sawing and let the motor cool down by leaving the machine running idle for some time.
7. Do not perform any design, assembly or construction activities on the table while the machine is switched
on.
Residual risks:
The following hazards may occur during the operation of this machine:
• Danger of injury to the fingers and hands while changing the saw blade;
• Danger of injury through flying debris from lhe workpiece;
• Danger of hearing damage. Take appropriate measures for the protection of hearing.
The sound levels stated are emission levels; they are not necessarily safe working levels. Even though
35
Publicidad
