höfats SPIN 900 Instrucciones De Uso página 20

CAUTION!
Risk of burns from using unsuitable
fire-starters!
Improper use of fire-starters poses a risk
of burns.
Use a stick lighter to light.
CAUTION!
Risk of burns!
The flame may be difficult to see after
lighting. You may burn yourself or come
into contact with burning liquid fuel while
attempting to check for a flame.
• After lighting, always put the glass cylinder
on the SPIN first.
• Do not look into the glass cylinder from above!
• Wear grill gloves when handling the SPIN
after lighting it.
WARNING!
Risk of fire from improper ignition of the
Bio-Burner!
If you light the Bio-Burner without first
inserting it into the SPIN, you can burn
yourself on the hot can when inserting it
into the wing body. In addition, burning
liquid fuel may leak and cause a fire.
• Only light the Bio-Burner after you have
inserted it into the body.
EXTINGUISHING THE FIRE FIGURE D
Extinguishing the Bio-Burner
• To extinguish the Bio-Burner, grasp the extinguishing cover by
the wire (Figure D1).
• Then lower the cover into the glass cylinder until it rests on the
Bio-Burner (Figure D2).
• Wait for the flame to go out and the SPIN to cool before lighting
or moving the SPIN again.
CAUTION!
Never use extinguishing covers from other
höfats products to extinguish the Bio-Burner!
Do not use any other covers than the
extinguishing cover to extinguish the SPIN!
Do not leave the SPIN unattended after
extinguishing without checking to ensure it
the flame is really out.
After extinguishing
After you have extinguished the Bio-Burner and all parts have
cooled down, you can do the following:
• Refill the Bio-Burner with fuel and ignite.
• Insert a new Bio-Burner into the SPIN, fill it up and ignite.
• Empty and discard any remaining fuel in the Bio-Burner.
Observe the local/national regulations for the disposal of liquid
fuel.
EN
WARNING!
Danger of fire and deflagration due to fuel
residues in the Bio-Burner.
Fuel residues in the Bio-Burner will also
evaporate after extinguishing and can form
a flammable mixture with air in the glass
cylinder of the SPIN
Do not leave any residual fuel in the Bio-
Burner when you are no longer using the
SPIN.
If possible, use up all the fuel in the Bio-
Burner in one burn.
CLEANING AND MAINTENANCE
To protect the surfaces and avoid contamination of the flame, you
should clean SPIN regularly and before each use.
WARNING!
Allow the SPIN to cool completely before
cleaning.
Cleaning the Bio-Burner
• Clean the Bio-Burner holder regularly with a damp cloth.
Cleaning the glass cylinder
• The glass cylinder is made of high-quality borosilicate glass
and is easy to clean with a soft cloth and soap.
• After cleaning, rinse the glass cylinder thoroughly to remove all
soap residue. Soap residue increases the risk of soot deposits
on the glass and can burn into the glass.
Cleaning the body and base
• Do not use any strong or abrasive solvents or scouring pads to
clean the body and the base or any other parts, as these can
corrode the surfaces and leave marks.
STORAGE
• Do not expose the SPIN to the elements for long periods of
time.
• When not in use, store the SPIN in a dry, well-ventilated place
away from dust.
CAUTION!
After a long period of storage, first remove
dirt deposits and dust before using the SPIN
again.
We recommend using the cover hood, which
is available as an accessory.
CAUTION!
Make sure all liquid fuel is burned before
storing the SPIN!