Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Winding theBobbin
Removing
the bobbin
Slide the hook cover release button to the right, and
remove the hook cover.
Lift the bobbin out.
_
Hook cover release
button
_
Hook cover
_
Bobbin
Setting
the spool
of thread
Place the spool of thread on the spool pin with the
thread coming
off the spool as shown.
• For an ordinary
spool:
Use the large spool holder.
_ Large spool holder
o For a narrow
or small
spool:
......
Use the small spool holder.
_
Small spool holder
Set the spool _
under the adai ionat spool pin,
place the felt,!
_ :i_sertinto
t6_
le.
_
Spool
........
_
Additional
_
Felt
.................
........
_
Spool stand
_
Hole for the additional
spool pin
Winding
the bobbin
NOTE:
winding.
Set the speed control lever at_
for bobbin
[1] Guide the thread around the bobbin winder thread
guide.
_
Bobbin winder thread guide
[2] Insert the thread through the hole on the bobbin,
threading
from the inside to the outside.
Put the
bobbin on the bobbin winder
spindle.
_
Bobbin winder
spindle
[3] Push the bobbin winder
spindle to the right. The
LED display shows [_i"
[41 With the free end of the thread held in your hand,
depress the foot control. Stop the machine
when
the bobbin has made a few turns, and cut the
thread close to the hole on the bobbin.
[5] Depress
the foot control again. When the bobbin is
fully wound,
it will stop automatically.
Return the
bobbin to its original
position by moving the spindle
to the left, and cut the thread as shown.
f
/
[i_iI
22
Publicidad
Tabla de contenido
