Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL ASSEMBLY INSTRUCTIONS
A Philips head screwdriver is required.
1
6
11
16
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY
VACUUM. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the powerhead off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on page 8 (Fig. 4).
5. Turn the collection tank on its side and insert the four caster feet into the slots on the collection
tank and tighten with supplied screws. Verify that the caster feet are mounted correctly. Do not
over-tighten screws (Fig. 5).
6. Position the left hose storage rack on the front side of the powerhead, just above the top edge
of the tank, as illustrated in Fig. 6. Squeeze the open sides of the left hose storage rack inward
and insert the open ends into the allocated slot. Verify that the rack is secured in place as shown
in Fig. 7. Install the right hose storage rack in the same way on the other side of the powerhead
as shown in Fig. 9, ensuring it is secured (Fig. 6 – 10).
NOTE: Hose storage rack may come pre-installed on some models.
3
2
8
7
12
13
17
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
4
9
14
18
9
5
10
15
Publicidad
