Publicidad
Idiomas disponibles
Idiomas disponibles
A
Product overview
Operation requirements
Location of Your Washer
Do Not Install The Washer:
1.
In an area exposed to dripping water or outside weather conditions. The ambient
temperature should never be below 15.6 °C for proper washer operation.
2.
In an area where it will come in contact with curtains or drapes.
3.
On carpet. The floor MUST be a hard surface with a maximum slope of 1.27 cm per 30 cm.
To make sure the washer does not vibrate or move, you may have to reinforce the floor.
Note: If floor is in poor condition, use 3/4" impregnated plywood sheet solidly
attached to the existing floor covering.
IMPORTANT: MINIMUM INSTALLATION CLEARANCES.
•
When installed in alcove: Top and Sides = 0 cm, Back = 7.6 cm.
•
When installed in closet: Top and Sides = 0 cm, Front = 5 cm, Back = 7.6 cm.
•
Closet door ventilation openings required: 2 louvers each 387 cm2, located 7.6 cm from
top and bottom of door.
Electrical Requirements
Read these instructions completely and carefully.
WARNING!
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK AND PERSONAL INJURY:
•
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS
APPLIANCE. Washer must be electrically grounded in accordance with local
codes and ordinances.
CIRCUIT - Individual, properly polarized and grounded 16-amp branch circuit fused with
16-amp time -delay fuse or circuit breaker.
POWER SUPPLY - 2-wire with ground, 220-240V~, single-phase, 50Hz, alternating current.
OUTLET RECEPTACLE - Properly grounded receptacle located so the power supply cord is
accessible when the washer is in an installed position.
GROUNDING REQUIREMENTS
Improper connection of the equipment grounding conductor can result in a risk of electrical
shock. Check with a licensed electrician if you are in doubt as to whether the appliance is
properly grounded.
44
EN
Publicidad
