GE AET05 Manual Del Propietario E Instrucciones De Instalación página 11

Installation instructions
131PREPARE THE AIR CONDITIONER
(cont.)
[] Attach the accordion panels to the case
using 3 Type A screws on each side.
Top mounting rail
Accordion
panel
Type
screws
BACK
Bottom mounting rail
[_] PREPARE THE WINDOW
Cut the window sash seal to the proper
length. Peel off the backing and attach the
seal to the underside of the window sash.
[] INSTALL THE AIR CONDITIONER
IN THE WINDOW
[A] Place the air conditioner on the stool with
the bottom mounting rail against its back
edge. Center it and close the window
securely behind the top mounting rail.
It should be level or slightly tilted to the
outside. Use a level; about a 1/3 bubble
will be the correct case slant to the outside.
/
Type C screws
['B] Extend the left and right accordion panels
to the vertical window sashes and attach,
through the holes in the panels, with 4
Type C screws, as appropriate.
INSTALL A SUPPORT BRACKET
AND THE FOAM TOP WINDOW
GASKET
[A] Attach the support bracket with one
Type C screw.
['_ Cut the foam top window gasket to the
window width.
['C-']Stuff the foam between the glass and the
window to prevent air and insects from
getting into the room.
/
11