Descargar Imprimir esta página

GE AET05 Manual Del Propietario E Instrucciones De Instalación página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

Remote Control
To ensure
proper
operation,
aim the remote
connol
at the sigaml receiver
on file air
condifioneL
The remora control sigmal has a range of
up m 20 feet.
ge.com
Make sure noflflng
is between
file ah conditioner
and the remote
control
flint could block file
signal.
Make sure batteries
are flesh and installed
correctly
as indicated
on file remote
conuol.
Cool Mode
Use file Coohnode at Low, Med, High or Auto Fan
Speed for cooling. Use the Temperature Increase • /
Decrease• pads to set the desired temperature
between 64°F and 86°F in 1°F increments.
2M1electronic dlemlostat is used to maintain die
room mmperamre. The compressor will cycle on
and off"m keep the room at the set level of comfort.
Set the tbemlosmt at a lower number and the indoor
air will become cooleL Set the tbemlosmt at a higher
number and the indoor air will become wamleL
NOTE: ff theair conditioner i s off andis thenturnedon
whileset toa Coolsettingor if turnedfroma fansetting
toa Coolsetting,it maytakeapproximately 3 minutes
forthecompressor to startandcoolingto begin.
CoolingDescriptions
ForNormalCooling--Selectthe Coolmode and
High or Med fan with a middle set temperature.
ForMaximumCooling--Select file Coolmode
and Highfan wifll a lower set mmperamre.
For Quieter & Nighttime Cooling--Select
d_e
CO01mode and LOWfan wifll a middle
set
mmpemture.
Energy Saver Mode
Controls the fan.
0N--The
fan will cycle on and offwith the
compressoL This results in wider vaIiafions of room
temperature
and humidity. NormaUy used when the
room is unoccupied.
NOTE: Thefanmaycontinue to run
fora shorttimeafter thecompressor cgclesoff.
OFF--The fan runs all the time, while die
compressor cycles on and off:
Fan Only Mode
Use the FanOnlyMode at Low,Medor Highfan
speed to provide air circulation and filtering
without cooling. Since fan only settings do not
provide cooling, a Set temperature
cannot be
enmred. The room mmpemmre
will appear
in the displ W.
NOTE: AutoFanSpeed cannot b e usedwhenin the
Fan OnlyMode.
Auto Fan Speed
Set to Autofan speed for the fan speed to
automatically
set to the speed
needed
m provide
optimum comfort settings wifll the set temperature.
If die room needs more cooling, file fan speed
will automatically incre_tse. If the room needs less
cooling, the fan speed will automatically decrease.
NOTE: AutoFanSpeed cannot b e usedwhenin the
Fan OnlyMode.
Power Outage Recovery Feature
In the case of a power outage
or interruption,
the
unit will automatically
re-start in the settings
last
used after the power is restored.
If the Delay 1-24hr
feature was set, it will resume countdown. You may
need to set a new time if desired.
5

Publicidad

loading

Este manual también es adecuado para:

Aew05Aew06Aew08