Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
(continued)
Attaching Miter Lock Knob
Locate the miter gauge lock knob from among the
loose parts, and thread shaft into miter detent assem-
bly as shown in illustration.
Miter Gauge
Shaft
Lock Knob
Figure: Miter Lock Knob
Assembling
Dust Elbow
And Dust Bag
1. With the miter arm locked in the down position,
push the dust elbow onto the dust port. Push the
dust bag onto the elbow and rotate both to desired
position.
2. Position dust chute/bag so that it does not interfere
with the tool during the cutting operation
for all
miter/bevel settings. Make sure dust bag does not
interfere with the slide rails during slide cutting.
3. The
dust bag requires
emptying
when full of
sawdust. Empty it frequently and after completion
of sawing. Carefully remove dust bag from dust
elbow.
Empty
dust
bag
in
proper
trash
bin by unzipping the bag. Be extremely careful of
dust disposed, materials in fine particle form may
be explosive. Do not throw sawdust on an open
fire.
Spontaneous
combustion,
may
in time,
result from
mixture
of oil or water
with dust
particles.
NOTE: The dust port accepts the Bosch VACO04
Vacuum Hose Adapter, which allows connection to a
Bosch 35mm vacuum hose.
When sawing chemically
pressure
treated lumber, paint that may be
lead based, or any other materials that may contain
carcinogens, use special precautions. A suitable res-
pirator must be worn by all personnel
entering the
work area. Work area should be sealed by plastic
sheeting and persons not protected should be kept
out until work area is thoroughly cleaned.
Dust Bag
Dust Elbow
Figure: Dust Elbow and Dust Bag
Dust
Port
12.
Publicidad
