Publicidad
Idiomas disponibles
Idiomas disponibles
Transporting,
Placement
& Mounting
Mounting Applications
Portable
Mounting
Using Clamps
If necessary, clamp the miter saw to a workbench or
table top by placing two (2) or more "C" clamps on
the clamping areas and secure.
NOTE: Be careful not to place clamps over the base
extension clamping levers.
Mounting with clamps will prevent access to some
wide miter angles.
Clamping
Areas
Clamping Areas
Figure: Portable Mounting Using Clamps
Adjusting the Four Position Switch Handle
Handle
J
Lock
Clamp
Handle
Rotation
Release
Lever
a.
b.
Figure: Setting Main Handle Position
Setting Main Handle
in
Desired
Position
The switch handle can be positioned in any of four
different
orientations,
depending
on the
cutting
situation and user preference:
a. Vertical b. 45 ° Left c. Horizontal d. 45 ° Right
To reposition the main handle:
1. Release handle lock clamp.
2. Pull and hold handle rotation release lever
3. Rotate handle to desired location.
4. Let go over
release
lever
to set handle
into
place.
Release
lever will retract down only in
one of the four (4) positions
Note:
Power switch can not be actuated
unless
release lever is retracted down. Do not attempt to
switch tool on between handle position, damage may
occur.
5. Lock the handle clamp.
Adjusting
the Four-Position
Handle
Lock Clamp Tension
1. Open handle lock clamp.
2. Using 1.5 mm Allen wrench, increase tension by
turning both setscrews 1/4 turn to the left, tighten
by
turning
to the
right.
Always
adjust
both
setscrews by the same amount.
3. Close handle lock clamp.
4. Check the tension.
20.
Publicidad
