Publicidad
Idiomas disponibles
Idiomas disponibles
Transporting,
Placement
& Mounting
To avoid injury always observe the
following:
• Unplug electric cord. Before transporting
the saw,
rotate head and lock assembly to 60 ° right miter,
lock into detent, slide head assembly to the middle
of it's rail, tighten the slide rail lock knob and lock
the head assembly in the lowered position.
Lifting
Saw
• To avoid back injury, hold the tool close to your
body when lifting. Bend your knees so you can lift
with your legs, not your back.
• Lift by using the cast-in carry handles
at each
side of the bottom of the base.
• Alternate
lifting
method:
When
picking
tool up
from ground, use rear carrying handle and front
carrying handle (above guard).
• Never
carry
the
tool
by the
slide
rails,
this
may cause blade damage.
• Never lift tool by holding main switch handle.
This may cause serious damage.
• Never carry the miter saw by the power cord or the
operational
handle. Attempting
to lift or carry the
tool by the power cord will damage the insulation
and the wire connections resulting in electric shock
or fire.
• Observe the position of the saw. People standing
behind it could be injured by thrown debris.
• Place the saw on a firm, level surface where there
is plenty of room for handling and properly support-
ing the workpiece.
• Bolt, nail or clamp the saw to its support.
Be careful
not to over-drive
nail
or over-torque
the bolt. This could
crack foot or damage base.
Mounting Applications
Mounting
to Workbench
Mount the saw using either the four bolt holes (5/16")
or the four nail holes to the workbench.
Check for
clearance to the left and right of the saw.
1. Each of the four mounting holes should be bolted
securely using 5/16" bolts, lock washers, and hex
nuts (not included).
2. Locate and mark where the saw is to be mounted.
3. Drill four (4) 5/16" diameter holes through work-
bench.
4. Place the miter saw on the workbench
aligning
holes in base with holes drilled in workbench.
Install bolts, lock washers
and hex nuts. As an
alternative, you can mount the saw using drywall
screws in the four nail holes.
Supporting
surface where saw is to be mounted
should
be examined
carefully
after mounting to
ensure that no movement can occur during use. If
any tipping or walking is noted, secure the work-
bench or stand before operating
the slide com-
pound miter saw.
Rear Carrying
Handle
\
Front Carrying
Handle
Bolt Hole
Nail Hole
Figure: Workbench Mounting
19.
Publicidad
