Publicidad
Preparation:
•
Ensure that the light is installed above eye level (at least 70 inches from
the floor) so that it is out of the line of anyones sight, and so that no one
can bump into the fixture.
•
Install the light close to the area where flies come in, but away from any
draft or wind.
•
Choose a location with high insect density, close to an electrical outlet
(hard wired availability) and easy serviceability.
•
Do not install the lamp near any competing light sources, such as bright
sunlit windows, indoor lighting fixtures etc. as this will render the FKWS18
light useless.
•
The distance between the lamp and the ceiling should be 24" or more for
maximum light attraction.
Instruction:
1. Lift the front cover and remove the UV bulb to avoid causing any damage
to it during the installation.
2. Hold the back plate of the fixture against the wall in your chosen location.
Determine the location you would like to install the light and mark the
screws' locations with a pencil.
3. Place the fixture aside. Drill holes on the marked locations and insert the
plastic raw plugs.
4. Next reposition the light fixing over the top of the holes you have prepared,
and insert one screw and tighten with a screw driver. Then repeat this for
the next screw.
5. Install the bulb and the sticky glue board. Note that the sticky side of the
board should be placed facing up.
6. Close the cover of the light.
7. Plug in the power cable into the mains power socket and switch on. Your
light should immediately illuminate.
NOTE: If you do not use the appliance for an extended period, ensure you
remove the plug from the electrical socket.
Installation
18
Publicidad
