Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
8 mm depth
adjustment
bolt
Hinge
8 mm depth
adjustment
bolt
Hinge
3. Lower limit position of saw blade when cutting a large workpiece
NOTE:
When cutting a workpiece exceeding 4-7/32" (107 mm) in height in right-
angle cutting or 2-3/4"(70 mm) in left bevel angle cutting or 1-3/4" (45 mm) in
right bevel angle cutting, adjust the lower limit position so that the base of
the motor head (see Fig. 9-a) will not come in contact with the workpiece.
To adjust the lower limit position of the saw blade, follow the procedure (1) shown in
Fig. 9-a.
Lower the motor head, and turn the 8 mm depth adjustment bolt and make
adjustments so that there can be a clearance of 5/64" to 1/8" (2 mm to 3 mm) between
the lower limit position of the motor head and the top of the workpiece at the saw
blade's lower limit position where the head of the 8 mm depth adjustment bolt
contacts the hinge.
4. Confirmation for use of sub fence (A)
WARNING:
18
Saw blade
Turntable
Fig. 9-a
Fig. 9-b
In the case of right bevel cutting, turn the sub fence (A) clockwise.
Unless it is turned clockwise, the main body or saw blade may contact
the sub fence (A), resulting in an injury.
(1) Turn the 8 mm depth adjustment
Gear case
bolt, change the height where the
bolt head and the hinge contacts,
and adjust the lower limit position
of the saw blade.
NOTE:
Turn
Gear case
Confirm that the saw
blade is adjusted so
that it will not cut into
the turntable.
Publicidad
Tabla de contenido
