Hitachi Koki C 12LSH Instrucciones De Seguridad Y Manual De Instrucciones página 33

For bevel cut setting
Turn the clamp lever on bevel section to the left and check that the position is stable
and that the bevel angle scale and the tip of the indicator are properly aligned. Then
tighten the clamp lever.
To process crown molding at
positions 1 and 4 in Fig. 38.
Type of Crown
Molding
Miter Angle
Setting
right 35.3°
45° Type
( mark)
right 31.6°
38° Type
( mark)
(1) Setting to cut crown moldings at positions 1 and 4 in Fig. 38 (see Fig. 39; tilt the motor
head to the left):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the motor head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the upper surface (A in Fig. 37) contacts the fence
as indicated in Fig. 41.
(2) Setting to cut crown moldings at positions 2 and 3 in Fig. 38 (see Fig. 40; tilt the head to
the left):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
Bevel Angle
Setting
left 30°
( mark)
left 33.9°
( mark)
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
To process crown molding at
positions 2 and 3 in Fig. 38.
Miter Angle Bevel Angle
Setting Setting
left 35.3° left 30°
( mark) ( mark)
left 31.6° left 33.9°
( mark) ( mark)
English
33