GE AGM24 Manual Del Propietario E Instrucciones De Instalación página 4

About the controlson the air conditioner.
Features and appearance may vary.
Lights next to
the touch pads
on the air
conditioner
Energy
control panel saver o n
indicate the
selected
settings.
Fan on
Cool o n Timer on
I COOL!
Air ConditionerControls
-0
RemoteControl
Controls
0
@
@
O
ON/OFFPad
TtlYns air conditioner on and off.
TEMP/TIME Increase •/Decrease • Pads
Use to set teinperature when in COOL Inode
or tile time when using tile TIMER feature.
MODE
Use to set tile air conditioner to COOL,
ENERGY SAVER or FANmode.
FAN SPEEDPad
Use to set tile tim speed to
LOW(F1),
MED (F2) or HIGH(F3).
0
0
TIMER Pad
ON--When tile air conditioner is off,
it can be set to automatically cOiile on in
1 to 24
houI_ at its previous setting.
Each
touch of tile Increase •/Decrease • pads
will set tile timer in hom_.
OFF--_A]len tile air conditioner is on,
it can be set to automatically ttlrn off' in
1 to 24 horns. Each touch _ff tile Increase • /
Decrease •
pads will set tile timer in hom_.
Tocancel _e timer, press tile TIMER pad
tmtil tile display time disappears.
Remote Control Signal Receiver
Display
Shows tile set temperature or time remaining
on _I//eY.
Power Outage Recovery Feature
In tile case of a power outage or interruption, tile
refit will automatically re-start in tile settings last
used after tile power is restored. Tile TlMERleatm'e
xfill reset to tile off *inal setting You max need to set
a new time if desired.
Remote Control
To
enstli'e proper opei'ation, aill/ tile i'elllote
control at tile signal receiver on tile air
conditionei:
Tile remote control signal has a range of
up to 21 feet.
Make sure nothing is between tile air conditioner
and tile remote control that could block tile
signal.
Make sure batmries are fresh and installed
correctly as indicated on the remote control
4