Publicidad
Idiomas disponibles
Idiomas disponibles
b) Turn the power switch to the on ("I") position - it should illuminate - and the
device will be in standby mode
c)
Set the filling speed and time interval (can be freely modified during
operation).
NOTE: in the case of thick, sticky filling, it is recommended to set a slower filling
speed.
d) Use the "Start" button to start the device to check that everything is working
properly, especially the auger modes - the Timer counts down the time until
the end of a particular cycle.
e) You can load material into the tank and start stuffing.
f)
One cycle is started by pressing the "Start" button or (optionally) the foot
pedal.
g) At the end of each cycle, the device stops and enters standby mode - the start
of each subsequent filling is activated by pressing the "Start" button or using
the foot pedal, and so on each time.
h) To temporarily stop the machine - press the "STOP" button on the speed
control panel. The pause can be canceled by pressing the "FWD" button.
NOTE: if you need to stop the machine suddenly, press the emergency stop
button. It will be possible to restart the device only after deactivating this
button - to do this, turn it according to the arrows marked on it until it springs
back from the active (pressed) position. After that, the device can be operated
as standard.
3.4.
Cleaning and maintenance
a)
After each operation, get rid of residual material from the tank and clean the
device immediately, for example, by also removing the filling transport augers.
Publicidad
