We recommend that you make a note of its serial number in this booklet prior to installation, so that you
can refer to it later (technical work, request for assistance, etc.).
Once the appliance is installed and loaded, access to it is not so easy.
CAUTION: no assistance can be provided without this information.
4. INSTALLATION INSTRUCTIONS
Before using this appliance
• Remove the exterior and interior packing.
• Before connecting the appliance to the power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• The door on this appliance can be opened from either the left or the right side and the maximum angle
of opening of the door is 100°.
• When disposing your appliance, please choose an authorized disposal site.
• Use two or more suitably qualified people to move and install the appliance. Failure to do so can result
in back or other injury.
• Place your wine cooler on a position that is strong enough to support it when it is fully loaded. To level
your wine cooler, adjust the front leveling leg at the bottom of the wine cooler.
• This appliance must be fixed at the top and the bottom using the rail provided for the purpose in order
to avoid any risk of tipping when the shelves are slid out.
• Adequate ventilation is required, do not block the front air outlet.
• Not designed for placement in adage or basement.
• The appliance is for indoor use only.
• This device is designed to be incorporated into fitted kitchen units.
• Connect the cellar to a single socket and be careful to support it, so that your wine cellar is perfectly
level (use of a spirit level is recommended). This will prevent any movement due to instability, causing
noise and vibration, and will ensure that the door seals perfectly.
• This appliance is intended to be used exclusively for the storage of wine.
• This appliance is using flammability refrigerant. So never damage the cooling pipe work during the
transportation.
Attention
• Store wine in sealed bottles.
• Do not overload the cabinet.
• Do not open the door unless necessary.
• Do not cover shelves with aluminum foil or any other shelf material which may prevent air circulation.
• Should the wine cooler be left empty for long periods it is suggested that the appliance is unplugged,
and after careful cleaning, leave the door ajar to allow air to circulate inside the cabinet in order to avoid
41