Publicidad
Idiomas disponibles
Idiomas disponibles
Resin: A sticky, sap-based substance that has
hardened.
Revolutions per Minute (RPM): The number of
turns completed by a spinning object in one
minute.
Ripping or Rip Cut: A cutting operation along
the length of the workpiece.
Saw-Blade Path: The area over, under, behind,
or in front of the blade, as it applies to the
workpiece, or the area that will be or has been
cut by the blade.
Set: The distance that the saw-blade tooth
is bent (or set) outward from the face of the
blade.
Spindle: The shaft on which the cutting tool is
mounted. Also called the Arbor.
Through Sawing: Any cutting operation where
the blade extends completely through the
thickness of the workpiece.
UNPACKING
WARNING: If any parts are broken or miss-
ing, DO NOT attempt to plug in the power cord
or operate the saw until the broken or missing
parts are replaced. Failure to do so could result
in possibly serious injury.
WARNING: Do not attempt to modify this
saw or create accessories not recommended for
use with this saw. Any such alteration or modi-
fication is misuse and could result in a hazard-
ous condition leading to possibly serious injury.
WARNING: To prevent accidental starting
that could cause serious personal injury, always
disconnect the tool from the power source
when assembling parts.
UNPACKING
This product has been shipped completely as-
sembled, except cutting blade.
1. Carefully remove the tool and the acces-
sories from the box. Make sure that all items
listed in the packing list are included.
2. Inspect the tool carefully to make sure that
no breakage or damage occurred during ship-
ping.
3. Do not discard the packing material until
you have carefully inspected and satisfactorily
operated the tool.
4. If any parts are damaged or missing, return
the product for replacement.
18
FEATURES
KNOW YOUR TOOL
2
3
4
5
6
1. FRONT HANDLE
2. ON/OFF SWITCH
3. LOWER GUARD RETRACTING
4. BASE PLATE
5. LOWER GUARD
6. RIP FENCE
7. BLADE
8. CUTTING MARK, 45º
9. RIP FENCE LOCK KNOB
10. BEVEL ADJUSTMENT KNOB
11. SPINDLE LOCK
OPERATION INSTRUCTIONS
WARNING: The maximum blade capacity of
your saw is 7-1/4 inches. Any blade larger than
7-1/4 inch will come in contact with the blade
guards. Never use a blade that is so thick that it
prevents the outer blade washer from engag-
ing with the flat side of the spindle. Blades that
are too large or too thick can result in an ac-
cident causing serious injury.
SAW BLADES
All saw blades need to be kept clean, sharp,
and properly set in order to cut efficiently. Us-
ing a dull blade places a heavy load on the saw
and increases the danger of kickback. Keep ex-
tra blades on hand, so sharp blades are always
available.
1
11
10
9
7
8
Publicidad
