Problem
Possible cause
Solulion
Theextractorfandoesnotworl<.
Thema'nscableisnotconnectedtothe
Connectmalnscabletothenetworl<.
network
There'snOCI.Jrrentinthe
network
ProvideCI.Jrrenttothene\WO(k
Thek,tCt1enhoodaoesnotedract
Filtersaresaturatedwithlal
Change or dean the active charcoal andlor metal
sutfloentlyor",;bra!es
filters.asthecasemaybe
ObStruction in the aire¡Ut conduct
Removetheobstruebon
Thelampsdonotllghtup
Thelamps
are bloWl1
Changethelamps
Thelampsare
sladl
Tightenthelamps
Cle3'ñ!B9and r:nain~~ce
- :J
During
cleaning
and maintenance
work,
make sure the safety
instructions
set out
on page 10 are complied
with.
Cleaning the hood body
.
If your kitchen hood is made from stainJess
steel, use proprietary cleaners
mentioned
in the product instructions.
Never use metallic scourers,
nor abrasive
or corrosive products.
Dry the kitchen hood using a cloth that
does not produce fibres.
The
use
of vapour
cleaners
is not
recommended.
Cleañing the metal fiIIers-
To remove the filters from their fittings, press
lightly on the locks and then pull them off.
The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease
products.
They can also be washed in a dishwasher.
In
this
case,
it is advisable
to stack
them
vertically
to avoid food residues
to stick to
them.
Cleaning
in a dishwasher
may damage
the
metallic surtace (blackening
it), although
this
will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit
them onto the kitchen hood.
l
CQ@9i¡i9lig6f,bliíl5.s-
Fig. 2 (Page 31)
Proceed as follows:
Open the corresponding
door (A). Remove
the metal filters.
Dismount the support (C) by loosening
the
screw (B).
Change
the
brokenl
burnt
out
lamp.
Maximum lamp power is 20 W (G.4).
Mount the support again (C).
Fit the metal filters. Close the door.
problem
solving
Proceed with the following checks before calling the Technical Service:
Sizes
ancf' sP-ecificaRons
-
- -
---
See page 30.
TEKA INDUSTRIAL
S.A. reserves the right to make changes and correclions
to its products as
it deems necessary, without altering their basic characteristics.
12
-+-
+
I